Cisco CTX2500 User Manual

2-64
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.0
78-18663-01
Chapter 2 Alarm Troubleshooting
Alarm Procedures
Clear the FORCED-REQ-SPAN Condition
Step 1 Complete the “Clear an External Switching Command on a Path Protection Span” procedure on
page 2-151.
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/cisco/web/support/index.html for more information or call Cisco TAC
(1-800-553-2447).
2.7.79 FP-LINK-LOSS
The FP-LINK-LOSS alarm is not used in the Cisco ONS 15310 platforms in this release. It is reserved
for development.
2.7.80 FRCDSWTOINT
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Object: NE-SREF
The Force Switch to Internal Timing condition occurs when the user issues a Force command to switch
to an internal timing source.
Note FRCDSWTOINT is an informational condition. It does not require troubleshooting.
2.7.81 FRCDSWTOPRI
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Objects: EXT-SREF, NE-SREF
The Force Switch to Primary Timing Source condition occurs when the user issues a Force command to
switch to the primary timing source.
Note FRCDSWTOPRI is an informational condition. It does not require troubleshooting.
2.7.82 FRCDSWTOSEC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Objects: EXT-SREF, NE-SREF
The Force Switch to Second Timing Source condition occurs when the user issues a Force command to
switch to a second timing source.
Note FRCDSWTOSEC is an informational condition. It does not require troubleshooting.

Cisco CTX2500 Specifications

General

Brand	Cisco
Model	CTX2500
Category	Network Card
Language	English