Administration
Managing Access and Configuring Other Management Options
Cisco Small Business WRV210 Administration Guide 85
7
• Device Name: Enter a suitable name to identify this device in the SNMP
software.
• Location: Enter the location of the Router.
• Get Community: Enter the SNMP community name for SNMP “Get”
commands.
• Write Community: Enter the SNMP community name for SNMP “Set”
commands.
• SNMP Trap-Community: Enter the SNMP community name for SNMP
“Trap” commands.
• SNMP Trusted Host: Enter the IP address of the machine where you are
running the SNMP software.
• SNMP Trap-Destination: Enter the IP address of the SNMP Manager to
send traps to. If desired, this may be left blank.
STEP 3 Click Save to save your settings, or click Cancel to refresh the page with the
previously saved settings.
Configuring Universal Plug and Play (UPnP) Settings
Universal Plug and Play (UPnP) can used to set up public services on your
network. When the UPnP function is enabled, Windows XP can add or delete
entries to the underlined UPnP Forwarding Table. Some Internet games require
enabling UPnP.
Manage this feature in the UPNP section of the Administration > Management
page.
STEP 1 Click Administration > Management in the navigation tree.
STEP 2 In the UPNP section, click Enabled to enable UPnP, or click Disabled to disable
this feature.
To Next Page
Loading...
Need help?
General
