Configuring a Virtual Private Network (VPN)
Configuring VPN Passthrough
Cisco Small Business WRV210 Administration Guide 66
5
Configuring VPN Passthrough
Use the VPN Passthrough page to allow VPN tunnels to pass through the Router’s
firewall using IPSec, L2TP, or PPTP protocols.
NOTE Disabling passthrough may prevent VPN clients from connecting to your network.
STEP 1 Click VPN > VPN Passthrough in the navigation tree.
STEP 2 Enable the protocol that you need for your network traffic:
• IPSec Passthrough: Internet Protocol Security (IPSec) is a suite of
protocols used to implement secure exchange of packets at the IP layer.
IPSec Passthrough is enabled by default to allow IPSec tunnels to pass
through the Router. To disable IPSec Passthrough, select Disabled.
• PPTP Passthrough: Point-to-Point Tunneling Protocol (PPTP) allows the
Point-to-Point Protocol (PPP) to be tunneled through an IP network. PPTP
Passthrough is enabled by default. To disable it, select Disabled.
To Next Page
Loading...
Need help?
General
