Configuring the Wireless Network
Configuring a Wireless Distribution System (WDS)
Cisco Small Business WRV210 Administration Guide 47
3
After receiving an RTS, the wireless station responds with a Clear to Send
(CTS) frame to acknowledge the right to begin transmission.
STEP 3 Click Save to save your settings, or click Cancel to refresh the page with the
previously saved settings.
Configuring a Wireless Distribution System (WDS)
If you need to extend the coverage of the Router by using a repeater, you can use
the WDS page to configure a Wireless Distribution System. This mode allows a
wireless client to connect to the Router through an access point, such as
WAP54GP or WAP54GPE, when operating in the Repeater Mode. You can install
up to three repeaters.
NOTE WDS works only with SSID1. Make sure that the channel and security settings are
the same for all WDS-enabled devices.
To Next Page
Loading...
