Operation QUANTUM TIC
3-14 10/04
The black filling bar ceases
to apply from serial no. and
installation of EPROM
350 812-5.
Floor conveyor
End of loading operation
When the crop presses against the lower shredder drum, it is moved
backwards slightly. The switch (6) closes and the floor conveyor is
automatically switched off. The filling indicator on the display is flashing.
Raise the pick-up and switch off the universal drive shaft.
Manual operation of floor
conveyor
If the automatic filling mode is not used or the load space is only to
be partially filled, the floor conveyor can be operated manually using
this key. Here the floor conveyor speed is always as previously set.
To Next Page
Loading...
