Operation QUANTUM TIC
3-22 10/04
Press this key to close the knife frame again.
Important! If the knife frame is totally open, it must be closed very carefully and
slowly. When folding up the frame, ensure that the cutting knives will not
collide with the rotor tines.
Engaging the floor
conveyor for loading
Press this key to fill the load space. The floor conveyor will run to the rear
as long as the key is pressed.
The floor conveyor speed depends on the tractor’s pto speed.
Important! During the loading operation, the tailgate must be completely closed,
otherwise the floor conveyor cannot be operated with the push button.
As soon as the crop pushes the tailgate slightly to the rear, the floor
conveyor is disengaged by a solenoid switch. The red LED (100%) on the
control box starts flashing. The floor conveyor drive can only be re-
engaged after the tailgate has been opened.
To Next Page
Loading...
Need help?
General
