The appropriate *.fwp format panel code is
available from the Drivers USB:
Drivers USB > ECLIPSE DRIVERS > Panel
Software > <Panel type>
Table 14-1: Required equipment
2. Start EHX on the PC.
3. Connect the PC to the matrix using either Ethernet or serial communications port.
4. Open the EHX configuration map within EHX.
5. Select System > Layout.
6. Right click the matrix and then select Firmware> Update Firmware.
7. The update firmware wizard dialogue is displayed. Click Next and ensure that the
Panel radio button is selected.
In Options:
• Selecting Automatic mode forces panels to upgrade automatically.
• Selecting Panel Prompt mode means that each panel user will be asked
to accept / decline the panel upgrade.
8. Click Next and then browse to the appropriate *.fwp file:
Drivers USB > ECLIPSE DRIVERS > Panel Software > <Panel type>
9. Click Next and confirm that the details displayed are correct.
10. Click Next and confirm that the download commences.
11. When the download has completed, click Finish to close the update firmware
wizard.
12. Ensure that the matrix commences downloading to connected panels of the
required type. If automatic download does not commence, power cycle the
panel(s) being upgraded.
To Next Page
Loading...
