Page 45 399G169 Rev B 27 April 2016
confirmation screen will appear. Select Yes to connect to a new system or No
to remain connected to the current system.
Available systems and previously registered systems will be visible on the
beltpack menu screen.
To connect the beltpack to the system, the system must be visible (V) and in
registration (pairing) mode. If the system is not in registration mode (P
visible), registration should be re-started (Step 1).
Connect the beltpack to the system using key D.
6.1.2.4 Enter pairing code
Enter the four-digit pairing code for the system using both rotary controllers
and the menu select key (D). The default code is 0000.
Note: The O.T.A. pin code is available from the Base Station menus and the CCM.
See Administration/Beltpacks on the Base Station,
Home/General/Wireless in the CCM.
To Next Page
Loading...
Need help?
General
