INSTALLATION MANUAL
CMA-5024 GLSSU
This document includes Proprietary Information and shall not be reproduced or communicated to third party
without prior written permission by CMC Electronics Inc.
Page E.1
November 21, 2008
APPENDIX E
AIRCRAFT PERSONALITY DATA (APD) CONFIGURATIONS
1. INTRODUCTION
To each GLSSU part number corresponds an APD File identified by its CID part number as per Figure
2 of Section I. This Appendix describes the contents of each APD File as a set of APD Configuration
forms and it provides blank forms for requesting a custom APD File, should the existing ones be
incompatible with the intended installation.
Should a custom APD File be required, CMC's Customer Support will assist the customer in submitting
the forms in section 2 herein, in compliance with the constraints specified in section 3 of this Appendix.
Following acceptance and processing of the request, CMC will create a new GLSSU part number,
(usually modifying only the variation i.e. the last 3 digits) to specify the new APD CID part number, and
generate an update to this manual in order to document it.
This Appendix describes the existing APD Files and provides the customer with form samples with the
instructions for filling them. It is organized as follows:
- Section 2 contains blank forms allowing the customer to define the set of custom APD
Configurations that will make up his custom APD File. Please consult CMC's customer support
for cost and delivery information and for assistance.
- Section 3 contains detailed information on each of the fields in the forms, and how to set them.
Please refer to it while filling the blank forms.
- Section 4 contains pre-filled forms defining the APD File for each available GLSSU part number.
Please consult it to see if an existing GLSSU part number fits the needs.
When requesting a custom APD File, the customer must fill-in the APD Configuration field of each
blank form with a number, from 0 to 15, that identifies uniquely each APD Configuration within the
desired APD File. The APD Configuration numbers in an APD File must be sequential (starting from
zero) and consecutive, without gaps. That is, at least one and no more than 16 forms must be
forwarded to CMC's Customer Support per APD File request.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
