INSTALLATION MANUAL
CMA-5024 GLSSU
This document includes Proprietary Information and shall not be reproduced or communicated to third party
without prior written permission by CMC Electronics Inc.
Page 23
Revision 1 Jan 19, 2009
7. EQUIPMENT SPECIFICATIONS (CMA-5024 GLSSU)
Figure 9 lists the applicable standards. Figure 10 lists the physical, power and reliability specifications.
Figure 11 lists actual environmental specifications of the GLSSU.
Figure 12 lists the performance specifications.
CHARACTERISTICS SPECIFICATION
RTCA
RTCA Document No. DO-160E: Environmental Conditions and Test
Procedures for Airborne Electronic/Electrical Equipment and
Instruments
RTCA Document No. DO-178B: Software Considerations In
Airborne Systems and Equipment Certifications
RTCA Document No. DO-254: Design Assurance Guidance for
Airborne Electronic Hardware.
RTCA Document No. DO-301: Minimum Operational Performance
Standards for Global Navigation Satellite Systems (GNSS) Airborne
Active Antenna Equipment for the L1 Frequency Band
RTCA Document No. DO-228 Change 1: Minimum Operational
Performance Standards for Global Navigation Satellite Systems
(GNSS) Airborne Antenna Equipment
RTCA Document No. DO-229D: Minimum Operational Standards
(MOPS) for the Global Positioning System /Wide Area
Augmentation System Airborne Equipment
RTCA Document No. DO-242A: Minimum Aviation System
Performance Standards for Automatic Dependent Surveillance
Broadcast (ADS-B)
RTCA Document No. DO-253C: Minimum Operational Performance
Standards for GPS Local Area Augmentation System Airborne
Equipment
FAA
TSO C-190: Technical Standard Order (TSO) for Active Airborne
Global Navigation Satellite System (GNSS) Antenna
TSO C-145b: Airborne Navigation Sensors using the Global
Positioning System augmented by the Satellite Based
Augmentation System
TSO C-146b: Technical Standard Order (TSO) for Stand-Alone
Airborne Navigation Equipment Using The Global Positioning
System Augmented By The Satellite Based Augmentation System
Figure 9. Applicable Standards (Sheet 1 of 2)
The document reference is online, please check the correspondence between the online documentation and the printed version.