EasyManua.ls Logo

Compaq EO1002 - Page 106

Compaq EO1002
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E-2 Compaq Server Console Switch User Guide
Compaq Confidential – Need to Know Required
Writer:
John Turner
Project:
Compaq Server Console Switch User Guide
Comments:
Part Number:
141555-002
File Name:
k-appe Updating the Firmware.doc
Last Saved On:
8/22/00 10:45 AM
To update the firmware:
1.
Connect the standard serial cable to the serial jack on the PC computer
and to the serial jack on the back panel of the switch.
2.
Press Print Scrn to open the OSD menus.
3.
Follow steps 4 through 6 if using the prompted input mode. Go to step 7
if using the single entry mode.
Prompted Input
4.
If C is the drive to which the file is saved, at the DOS prompt type:
C:\Update.exe
then press Enter.
5.
At the prompt type the filename. The filename will have a .bin
extension. Press Enter.
6.
At the prompt type the serial port number of the computer to which the
switch is attached. Press Enter.
If the data was typed correctly, a message appears on your computer
notifying you that the update for the switch is in process.
Go to step 8.
Single Entry
7.
If + is the drive to which the file is saved, at the DOS prompt type:
C:\UPDATE.EXE filename port number
then press Enter.
If data was typed correctly, a message appears on the computer
notifying you that the update is in process.
8.
Once the firmware is updated, a message displays:
100% Complete. Download completed successfully. Thank you for using
COMPAQ products.
The switch automatically reboots after the update is completed.
NOTE:
If the update was unsuccessful (due to a power outage, for example), repeat the
process.

Table of Contents