Contax U4R - Erasing All the Images (ERASE ALL)

Introduction Getting Ready Taking Pictures Playback Set Up
EN-106
BACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Erasing all the images (ERASE ALL)
You can use the procedure below to erase all the images recorded on a
memory card.
1 Turn the camera on and press the mode
buttons UD until "P" lights up on the
mode select LED.
2 Press the MENU button K to display the menu icons.
3 Move the selector lever left l or right r
to select ERASE MULTIPLE [I] and press
E.
The multiple erase screen appears.
4 Move the selector lever up u or down d
to select [ERASE ALL], then press E.
A message appears asking you to confirm that you want to erase the
images.
5 Move the selector lever up u to select
[EXECUTE], then press E.
All the images are erased and the "NO IMAGE" message appears.
A Important
• You cannot erase protected images (Æ p.107).
• When you erase an image with a postrecorded voice message (Æ p.110
), the sound file
is also erased.
A Important
If there are images still shown after you use
[ERASE ALL], those images may be protected. To
forcibly erase all the images, format the memory
card. ( "
[FORMAT] Initializing a Memory Card"
Æ p.163
)
ERASE MULTIPLE
ERASE MULTIPLE
SELECT AND ERASE
ERASE ALL
RETURN
ERASE ALL?
EXECUTE
CANCEL