Contax U4R - Erasing a Recorded Message

Introduction Getting Ready Taking Pictures Playback Set Up
EN-113
BACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Erasing a recorded message
Use the procedure below to erase a postrecorded voice message.
1 Turn the camera on and press the mode
buttons UD until "P" lights up on the
mode select LED.
2 Press the MENU button K to display the menu icons.
3 Move the selector lever left l or right r
to select POSTRECORDING [p] and press
E.
4 Move the selector lever left l or right r to select the image
with the voice message you want to erase.
5 Move the selector lever up u to select
[EXECUTE], then press E.
The voice message is erased and the "RECORD SOUND?" message
appears.
6 Press the MENU button K.
A Important
Audio cannot be erased from protected images.
POSTRECORDING
EXECUTE
CANCEL
ERASE SOUND?