Contax U4R - Selecting Scenes to Automatically Set the Focus and Flash; Selecting the Scene Mode

Introduction Getting Ready Taking Pictures Playback Set Up
EN-53
NEXT
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Selecting Scenes to Automatically Set the Focus and Flash
The camera can be set to the optimal shooting settings for any subject.
Selecting the Scene Mode
«Applicable mode: C»
1 Turn the camera on and press the mode
buttons UD until "C" lights up on the
mode select LED.
2 Press the SCENE button I.
The scene mode menu is displayed.
3 Move the selector lever up, down, left or
right udlr to select the scene mode
that suits the subject.
Refer to p.54 for details on each of the scene modes.
4 Press E.
The scene mode is set. You can now shoot using the selected mode.
A Important
• This setting is retained when you turn the camera off.
• Each time you change the scene mode, the focus, flash and other camera settings are
reset to the default settings for the new mode.
SCENE MODE
CANCEL
SPORTS ACTION