Need help?Do you have a question about the CPG Compuprint SP 40 and is the answer not in the manual?
General| Print Technology | Dot Matrix |
|---|---|
| Resolution | 360 x 360 dpi |
| Interface | Parallel, Serial, USB |
| Noise Level | 55 dBA |
| Paper Handling | Continuous forms, cut sheets |
| Number of Pins | 24-pin |
Describes the printer's main characteristics and functions.
Details the product's intended use, capabilities, and benefits.
Identifies external parts of the printer with diagrams.
Explains the printer's mechanical, electromechanical, and electronic components.
Lists detailed technical specifications for the printer.
Details MTTR, MTBF, duty cycle, and component life.
Introduces removal/installation, safety, and necessary tools.
Step-by-step guide for removing the top and main covers.
Detailed procedure for removing the print head assembly.
Steps to remove the main mechanical assembly.
Procedures for removing optional, backpanel, engine, and controller boards.
Instructions for removing the operator panel.
Guides for removing carriage, pulley, selector, and paper motors.
Procedures for removing home and ribbon sensor assemblies.
Steps to remove carriage and Mylar bar assemblies.
Procedures for removing rear/front rollers and selector cam.
Instructions for removing sensor board, platen, and print head cables.
Introduction to printer operability and control panel functions.
Details on operator panel keys and LEDs and their meanings.
Explains how to enter setup mode and print self-test pages.
Steps for configuring printer settings using forms and parameters.
Guide to configuring the printer using a web browser via NIC.
Instructions for installing and using the SP40setup application for configuration.
How to print the network interface configuration page.
Introduction to maintenance, initial inspections, and required tools.
Guidelines for cleaning printer components and maintaining appearance.
Points for lubrication and importance of correct paper specifications.
Recommendations for consumables and overview of firmware update methods.
Guidance on identifying and resolving recoverable and unrecoverable errors.
Tables for diagnosing issues and troubleshooting power-related problems.
Procedures for resetting ribbon and print head life counters.
Introduction to the printer's built-in T&D capabilities.
Step-by-step guide to initiate and navigate T&D tests.
Details on specific T&D tests, flow charts, and sequential actions.
Explains how to interpret errors, LED indicators, and error code lists.
Lists necessary tools and accessories for running T&D tests.
Guidance on interpreting printouts from T&D tests like print adjustment.
How to monitor T&D messages via serial interface using terminal software.
General characteristics that documents must meet for proper printing.
Detailed dimensions and weight requirements for single sheets.
Dimensions and requirements for multiple page and single page passbooks.
Electrical characteristics and architecture of the print head.
Electrical specifications and layouts for carriage, paper, and selector motors.
Details on home, edge, ribbon sensors, and sensor board wiring.
Procedure for adjusting the gap between the print head and platen.
Steps for adjusting paper and carriage belt tension.
Procedure for ensuring correct gap between upper and lower rollers.
To Next Page