CPG Compuprint SP 40 - Led Meaning During T&D Error Condition; Table 5.5 Led Status for N° of Test in Error Condition

Maintenance Manual SP 40
Rev. 005
97
Chapter 5
Test & Diagnostic
5.7.1 Led Meaning during T&D Error Condition
If the operator panel has not the LCD display installed, when the printer recognizes an error, a pressure on LQ key
allows to show up to 4 different led combinations (in the meantime the buzzer sound switch from normal to short
beep every 1 sec).
The table below shows the led condition after the first pressure of ON LINE key (test in error) during the test
failure detection.
Nº Test
LEDS
L4
L3
L2
L1
Test 1
l
l l ¡
Test 2
l
l ¡ l
Test 3
l
l ¡ ¡
Test 4
l
¡ l l
Test 5
l
¡ l ¡
Test 6
l
¡ ¡ l
Test 7
l
¡ ¡ ¡
Test 8
¡
l l l
Test 9
¡
l l ¡
Test 10
¡
l ¡ l
Test 11
¡
l ¡ ¡
Test 12
¡
¡ l l
Test 13
¡
¡ l ¡
Table 5.5 Led Status for N. of test in error