Maintenance Manual SP 40
Rev. 005
73
Chapter 3
Operabilty and Configuration
3.5.4 How to download to SP40 an existing configuration file
A configuration file, generated with the SP40 setup tool as previously described, can be simply used to duplicate the
same configuration on more printers.
SP40 unit has to be powered on in normal mode, connected to the PC through any active interface (Centronics or
Serial port).
Type: copy wnvm.dmp lpt1: /b command from a DOS shell,
where wnvm.dmp is the configuration file name.
The printer receives the file, checks for valid configuration format and in such a case the received content is recorded
into the non volatile memory.
After that the printer restarts the execution and downloaded configuration becomes the active.
Warning :
Configuration files generated by SP40setup tool are allowed to be used only on printers having te same firmware
version of the unit used to generate the file!
In any other case the received file is discarded by the printer without any change on NVM!
To Next Page
Loading...