2.1.278. base64_decode_failed (ID: 00200658)
Default Severity ERROR
Log Message IMAPALG: Base 64 decode failed. Attachment blocked
Explanation The data sent to Base64 decoding failed. This can occur if the email
sender sends incorrectly formatted data. The attachment has been
blocked.
Gateway Action block_data
Recommended Action Research how the sender is encoding the data.
Revision 1
Parameters filename
filetype
sender_email_address
Context Parameters ALG Module Name
ALG Session ID
2.1.279. command_blocked (ID: 00200659)
Default Severity WARNING
Log Message IMAPALG: Command <command> blocked.
Explanation The client is sending command that are not allowed. The command
will be blocked.
Gateway Action block
Recommended Action If the command are to be allowed change the Alg
configuration.Note: The STLS command is allways blocked!.
Revision 1
Parameters command
Context Parameters ALG Module Name
ALG Session ID
2.1.280. unknown_command_blocked (ID: 00200660)
Default Severity WARNING
Log Message IMAPALG: Unknown command blocked.
Explanation The client is sending unknown command. The command will be
blocked.
Gateway Action block
Chapter 2: Log Message Reference
156
To Next Page
Loading...
