2.23. HWM
These log messages refer to the HWM (Hardware monitor events) category.
2.23.1. temperature_alarm (ID: 04000011)
Default Severity WARNING
Log Message Temperature monitor <index> (<name>) is outside the specified
limit. Current value is <current_temp> <unit>, lower limit is
<min_limit>, upper limit is <max_limit>
Explanation The unit may be overheating, this may be because the cooling is
failing or to hot enviroment.
Gateway Action none
Recommended Action Shutdown the unit and determine the problem.
Revision 1
Parameters index
name
unit
current_temp
min_limit
max_limit
2.23.2. temperature_normal (ID: 04000012)
Default Severity WARNING
Log Message Temperature monitor <index> (<name>) is outside the specified
limit. Current value is <current_temp> <unit>, lower limit is
<min_limit>, upper limit is <max_limit>
Explanation The sensor reports that the temperature value is back in the normal
range.
Gateway Action None
Recommended Action None.
Revision 1
Parameters index
name
unit
current_temp
min_limit
max_limit
2.23.3. voltage_alarm (ID: 04000021)
Chapter 2: Log Message Reference
285
To Next Page
Loading...
