D-Link DFL-260E

<remotegw> on <iface>
Explanation MPPE is required by the configuration but the MPPE negotiation
failed. Session will be closed.
Gateway Action None
Recommended Action Make sure the peer is capable of MPPE encryption, or disable the
MPPE requirement.
Revision 1
Parameters iface
sessionid
remotegw
2.37.10. l2tp_session_request (ID: 02800010)
Default Severity NOTICE
Log Message L2TP session request sent. Tunnel ID: <tunnelid>
Explanation An L2TP session request has been sent over the specified L2TP
tunnel.
Gateway Action None
Recommended Action None.
Revision 1
Parameters tunnelid
2.37.11. l2tp_session_up (ID: 02800011)
Default Severity NOTICE
Log Message L2TP session up. Tunnel ID: <tunnelid>, Session ID: <sessionid>,
Auth: <auth>, MPPE: <mppe>
Explanation The L2TP session negotiation has completed successfully.
Gateway Action None
Recommended Action None.
Revision 1
Parameters tunnelid
sessionid
auth
mppe
2.37.12. l2tp_no_userauth_rule_found (ID: 02800014)
Chapter 2: Log Message Reference
460