Explanation The end of an application protocol has been recognized by the
application control function.
Gateway Action None
Recommended Action None.
Revision 2
Parameters application
origsent
termsent
ssl_inspected
Context Parameters Connection
2.4.4. no_valid_license (ID: 07200004)
Default Severity CRITICAL
Log Message Application Control disabled
Explanation Application Control has been disabled due to license restriction.
Gateway Action application_control_disabled
Recommended Action Extend valid time for Application Control.
Revision 3
2.4.5. application_control_disabled (ID: 07200005)
Default Severity CRITICAL
Log Message Application Control disabled
Explanation Application Control has been disabled due fatal subsystem failure.
Traffic will be treated as 'unknown' by Application Control.
Gateway Action treat_traffic_as_unknown
Recommended Action Restart the device or restore the system from a full system backup to
restore Application Control functionality. It is also possible to
configure the device to automatically restart if Application Control is
disabled due to fatal failure through the Application Control setting
'Restart On Fatal Failure'.
Revision 1
2.4.6. application_control_disabled (ID: 07200006)
Default Severity CRITICAL
Log Message Application Control disabled
Chapter 2: Log Message Reference
185
To Next Page
Loading...
