Context Parameters ALG Module Name
ALG Session ID
2.1.120. failed_to_send_response_code (ID: 00200255)
Default Severity NOTICE
Log Message FTPALG:Failed to send the response code.
Explanation The FTP ALG could not send the correct response code to the client.
Gateway Action none
Recommended Action None.
Revision 1
Context Parameters ALG Module Name
2.1.121. illegal_command (ID: 00200267)
Default Severity WARNING
Log Message FTPALG: REST from <peer> not allowed, rejecting command
Explanation The client tried to issue a "REST" command, which is not valid since
the client is not allowed to do this. The command will be rejected.
Gateway Action rejecting_command
Recommended Action If the client should be allowed to do issue "REST" commands, modify
the FTPALG configuration.
Revision 1
Parameters filename
peer
Context Parameters ALG Module Name
ALG Session ID
Connection
2.1.122. https_not_allowed (ID: 00200270)
Default Severity ERROR
Log Message HTTPS protocol is not allowed.
Explanation Allowed protocols in ALG don't include HTTPS.
Gateway Action block
Recommended Action None.
Chapter 2: Log Message Reference
94
To Next Page
Loading...
