D-Link DFL-260E

been reached. NATPool subsystem must replace an active state
since no lingering states exist.
Gateway Action replace_active
Recommended Action Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
Revision 1
Parameters poolname
num_states
replacedip
2.39.10. registerip_failed (ID: 05600011)
Default Severity WARNING
Log Message Request to activate already active Translation IP address <ip> in
pool <poolname>
Explanation Attempt to activate an already active Translation IP.
Gateway Action None
Recommended Action None.
Revision 1
Parameters poolname
ip
2.39.11. registerip_failed (ID: 05600012)
Default Severity WARNING
Log Message Too many Translation IP addresses requested for <poolname>
Explanation To many Translation IP addresses was requested for NAT Pool.
Dropping this address.
Gateway Action None
Recommended Action None.
Revision 1
Parameters poolname
2.39.12. dynamicip_failed (ID: 05600013)
Default Severity ERROR
Log Message Failed to fetch new Translation IP address from IP Pool <poolname>
Chapter 2: Log Message Reference
472