DGS-3100 Series Gigabit Stackable Managed Switch User Manual
3
Set Terminal Baud-Rate
Use the Set Terminal Baud-Rate option to define the Baud-Rate. The Baud-Rate is the serial bit rate used to communicate
with the management host. The Baud-Rates values are: 2400, 4800, 9600, 19200, 38400. The default Baud-Rate value is
9600.
To set the terminal Baud-Rate:
1. On the Startup menu, press “2”.
The following prompt is displayed:
Set new device Baud rate: _
2. Press Enter to apply changes.
Defining Stacking Units
Use the Stack menu option to display the current stack unit ID list and define an alternative unit ID (stack membership
number). Unit ID 0 is allocated for auto-numbering, which is the factory default. Refer to Managing Stacking for further
reference
.
To access the stack menu:
1. On the Startup menu, press “3”.
The following prompt is displayed:
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Back
Enter your choice or press ‘ESC’ to exit:
2. To display the current unit stack ID list, press “1”.
The following prompt is displayed:
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Back
Enter your choice or press ‘ESC’ to exit:
Current working mode is stacking.
Unit stack id set to 0.
===== Press Enter to Continue ====
3. To change the unit ID (stack membership number), press “2”.
The following prompt is displayed:
To Next Page
Loading...
Need help?
General
