D-Link DGS-3100 SERIES User Manual

DGS-3100 Series Gigabit Stackable Managed Switch User Manual
50
Defining SNMP Groups
The SNMP Group Table Page provides information for creating SNMP groups and assigning SNMP access control
privileges to SNMP groups. Groups enable network managers to assign access rights to specific device features or feature
aspects. To define SNMP groups:
1. Click Configuration > SNMP Settings > SNMP Group Table. The SNMP Group Table Page open
s:
Figure 0-13 SNMP Group Table Page
The SNMP Group Table Page contains the following fields:
Field Description
Group Name
Defines the user-defined group name to which access control rules are applied (limited to 30
alphanumeric characters).
Read View Name
Defines a Read Only view. The Read Only view management access is restricted to read-only,
and changes cannot be made to the assigned SNMP view. The possible values are:
Community/View
TestReadView
PWriteView
PrivateView
Write View Name
Defines a Write view. The Management view access is read/write, and changes can be made to
the assigned SNMP view. The possible values are:
Community/View
TestReadView
PWriteView
PrivateView

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C