xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 9- 5. Access Profile Configuration (IP)
The following parameters can be set, for IP:
Parameter Description
Profile ID (1-6)
Type in a unique identifier number for this profile set. This value can be set from 1 -6.
Type
Select profile based on Ethernet (MAC Address), IP or IPv6 address. This will change the
menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's header.
Source IP Mask
Enter an IP address mask for the source IP address.
Destination IP Mask
Enter an IP address mask for the destination IP address.
DSCP
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding.
Protocol
Selecting this option instructs the Switch to examine the protocol type value in each frame's
header. Then the user must specify what protocol(s) to include according to the following
guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP)
field in each frame's header.
Select IGMP to instruct the Switch to examine the Internet Group Management Protocol
(IGMP) field in each frame's header.
Select TCP to use the TCP port number contained in an incoming packet as the forwarding
criterion. Selecting TCP requires that you specify a source port mask and/or a destination
port mask.
• src port mask - Specify a TCP port mask for the source port in hex form (hex 0x0-
178
To Next Page
Loading...
