xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Configure the parameters listed below:
Parameter Description
Index
Syslog server settings index (1-4).
Server IP
The IPv4 address of the Syslog server.
Severity
This drop-down menu allows you to select the level of messages that will be sent. The
options are Warning, Informational, and All.
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font means the facility values that the Switch
currently now.
Numerical Facility
Code
Facility
0
1
2
3
4
5
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by syslog line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
security/authorization messages
FTP daemon
NTP subsystem
log audit
log alert
clock daemon
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
local use 6 (local6)
local use 7 (local7)
UDP Port (514 or
6000-65535)
Type the UDP port number used for sending Syslog messages. The default is 514.
Status
Choose Enabled or Disabled to activate or deactivate.
To set the System Log Server configuration, click Apply. To delete an entry from the System Log Server window, click the
corresponding
under the Delete heading of the entry to delete. To return to the Current System Log Servers window, click the
Show All System Log Servers
link.
System Log Save Mode Settings
The System Log Save Mode Settings window may be used to choose a method for which to save the switch log to the flash
memory of the Switch. To view this window, click Administration > System Log > System Log Save Mode Settings.
Figure 6- 24. System Log Save Mode Settings
Use the pull-down menu to choose the method for saving the switch log to the Flash memory. The user has three options:
57
To Next Page
Loading...
Need help?
General