xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Time in HH MM SS
Enter the current time in hours, minutes, and seconds.
Click Apply to implement your changes.
Time Zone and DST
The following are windows used to configure time zones and
Daylight Savings time settings for SNTP. Click Administration
> SNTP Settings > Time Zone and DST, to display the
following window.
The following parameters can be set:
Parameter Description
Time Zone and DST Settings
Daylight
Saving Time
State
Use this pull-down menu to enable or
disable the DST Settings.
Use this pull-down menu to specify the
amount of time that will constitute your
local DST offset - 30, 60, 90, or 120
minutes.
Daylight
Saving Time
Offset in
Minutes
Use these pull-down menus to specify
your local time zone's offset from
Greenwich Mean Time (GMT.)
Time Zone
Offset from
GMT in +/-
HH:MM
Figure 6- 27. Time Zone and DST Settings window
DST Repeating Settings - Using repeating mode will enable DST seasonal time adjustment. Repeating mode
requires that the DST beginning and ending date be specified using a formula. For example, specify to begin DST on
Saturday during the second week of April and end DST on Sunday during the last week of October.
From: Which Day
Enter the week of the month that DST will start.
From: Day of Week
Enter the day of the week that DST will start on.
From: Month
Enter the month DST will start on.
From: Time in HH:MM
Enter the time of day that DST will start on.
To: Which Day
Enter the week of the month the DST will end.
To: Day of Week
Enter the day of the week that DST will end.
To: Month
Enter the month that DST will end.
To: Time in HH:MM
Enter the time DST will end.
DST Annual Settings - Using annual mode will enable DST seasonal time adjustment. Annual mode requires that
the DST beginning and ending date be specified concisely. For example, specify to begin DST on April 3 and end
DST on October 14.
From: Month
Enter the month DST will start on, each year.
From: Day
Enter the day of the month DST will start on, each year.
From: Time in HH:MM
Enter the time of day DST will start on, each year.
To: Month
Enter the month DST will end on, each year.
61
To Next Page
Loading...
Need help?
General