xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Parameters Description
Box ID
Displays the Switch’s order in the stack.
User Set
Box ID can be assigned automatically (Auto), or can be assigned statically. The default is Auto.
Type
Displays the model name of the corresponding switch in a stack.
Exist
Denotes whether a switch does or does not exist in a stack.
Priority
Displays the priority ID of the Switch. The lower the number, the higher the priority. The box
(switch) with the lowest priority number in the stack denotes the Primary Master switch.
MAC Address
Displays the MAC address of the corresponding switch in the switch stack.
PROM Version
Shows the PROM in use for the Switch. This may be different from the values shown in the
illustration.
Runtime Version
Shows the firmware version in use for the Switch. This may be different from the values shown in
the illustrations.
H/W Version
Shows the hardware version in use for the Switch. This may be different from the values shown
in the illustration.
Topology
Show the current topology employed using this Switch.
My Box ID
Displays the Box ID of the Switch currently in use.
Master ID
Displays the Unit ID number of the Primary Master of the Switch stack.
Backup Master
Displays the Unit ID of the Backup Master of the switch stack.
Box Count
Displays the number of switches in the switch stack.
Module Information
The Module Information display shows information about any installed modules. To view this window click, Monitoring >
Module Information.
Figure 11- 3. Module Information window
Module information displayed:
Parameter Description
ID
The slot number where the module is installed.
Module Name
The full name of the module installed.
Rev. No.
The version of the installed module.
Serial
The serial number of the module.
Description
A brief description of the type of module.
249
To Next Page
Loading...
Need help?
General