xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
MAC Notification Settings
MAC Notification is used to monitor MAC
addresses learned and entered into the forwarding
database. To globally set MAC notification on the
Switch, open the following window by clicking
Administration > MAC Notification Settings.
Global Settings
The following parameters may be viewed and
modified:
Parameter Description
State
Enable or disable MAC
notification globally on the
Switch
Interval (sec)
The time in seconds
between notifications.
The maximum number of
entries listed in the history
log used for notification. Up
to 500 entries can be
specified.
History size
Port Settings
To change MAC notification settings for a port or
group of ports on the Switch, configure the
following parameters.
Parameter Description
Unit
Choose the switch in the
switch stack for which to
configure these settings.
From…To
Select a port or group of ports
to enable for MAC notification
using the pull-down menus.
Enable MAC Notification for
the ports selected using the
pull-down menu.
State
Click Apply to implement changes made.
Figure 6- 28. MAC Notification Settings
63
To Next Page
Loading...
Need help?
General