D-Link xStack DGS-3426 - SNMP Trap Settings; SNMP User Table

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
SNMP Trap Settings
The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click Administration > SNMP Manager > SNMP Trap Settings:
Figure 6- 50. SNMP Trap Settings window
To enable or disable the Traps State and/or the Authenticate Traps State, use the corresponding pull-down menu to change and
click Apply.
SNMP User Table
The SNMP User Table displays all of the SNMP users currently configured on the Switch.
To view this window click, Administration > SNMP Manager > SNMP User Table.
Figure 6- 51. SNMP User Table window
To delete an existing SNMP User Table entry, click the below the Delete heading corresponding to the entry to delete.
To display the detailed entry for a given user, click on the View button. This will open the SNMP User Table Display window,
as shown below.
Figure 6- 52. SNMP User Table Display
The following parameters are displayed:
Parameter Description
User Name
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
Group Name
This name is used to specify the SNMP group created can request SNMP messages.
84