xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
To view the following table, click Security > Access Authentication Control > Enable Method Lists:
Figure 10- 29. Enable Method List Settings window
To delete an Enable Method List defined by the user, click the under the Delete heading corresponding to the entry desired to
be deleted. To modify an Enable Method List, click on its hyperlinked Method List Name. To configure a Method List, click the
Add button.
Both actions will result in the same screen to configure:
Figure 10- 30. Enable Method List - Edit window
Figure 10- 31. Enable Method List - Add window
To define an Enable Login Method List, set the following parameters and click Apply:
Parameter Description
Method List Name
Enter a method list name defined by the user of up to 15 characters.
Method 1, 2, 3, 4
The user may add one, or a combination of up to four (4) of the following authentication
methods to this method list:
local_enable - Adding this parameter will require the user to be authenticated using the local
enable password database on the Switch. The local enable password must be set by the user
225
To Next Page
Loading...
Need help?
General