Dahua HCVR8204A-S3 - Upnp

152
Figure 4-124
Step 3 Click Apply or Save to complete setup.
4.11.9 UPnP
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN.
Preparation
 Login the router, set router WAN IP address.
 Enable router UPnP function.
 Connect the DVR with the LAN port of the router.
Step 1 Input the router IP address in the LAN in Figure 4-116 (main
menu->Setting->Network->TCP/IP).
Step 2 From main menu->Setting->Network->UPnP.
Enter UPnP interface. See Figure 4-125.
Step 3 Set parameters.
 UPNP Enable/Disable: Turn on or off the UPNP function of the device.
 Status: When the UPNP is offline, it shows as “Searching”. When the UPNP works it
shows “Success”
 Router LAN IP: It is the router IP in the LAN.
 WAN IP: It is the router IP in the WAN.
 Port Mapping list： The port mapping list here is the one to one relationship with the
router’s port mapping setting.
 List：
 Service name：Defined by user.
 Protocol： Protocol type