4. Click add button and then click to save.
One group position setting is complete; you can view at the list. See Figure
4-175.
Figure 4-175
5. Repeat the above steps (Step 2-4) to set at least three group positions.
Note
For one PTZ camera, there must be four calibration groups. System
max supports 8 group positions. Please make sure the calibration
position is accurate.
For the first calibration group position, please select the reference
objects at the far distance to enhance the trigger accuracy.
6. Click OK button.
Calibration setup is complete. Go back to the smart track interface, the
status is shown as .
Note
After you complete smart track setup, please go to the preview interface and
then right click mouse, and then select Smart track, you can view the
corresponding video. Please refer to chapter 4.14.7 for detailed information.
4.14.8 Alarm Settings
Before operation, please refer to chapter 3.7 Alarm input and output connection
properly connected alarm devices such as buzzer.
4.14.8.1 Local alarm
Local alarm refers to the alarm signal system detects from the alarm input port.
Step 1 From Setting->Event->Alarm->Local.
Enter local alarm interface. See Figure 4-176.
Step 2 Set parameters.
Alarm in: Here is for you to select channel number.
Type: normal open or normal close.
PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to
preset, tour& pattern when there is an alarm. Click “select” button, you can see an
interface is shown as in Figure 4-177.
Period: Click set button, you can see an interface is shown as in Figure 4-178. There
To Next Page
Loading...
