Figure 5-112
Step 2 Set alarm mode of each channel. Set parameters.
The corresponding event triggers the alarm output or cancels alarm.
Forcedly trigger alarm output.
Forcedly cancel or close alarm output.
Here you can view alarm output port status. The alarm is enabled if the
icon is highlighted.
Click the button, you can clear all alarm output status.
Step 3 Click Save to complete the setup.
5.7.4 Storage
5.7.4.1 Basic
It is to manage HDD storage space.
Step 1 From main menu->Setup->Storage->Basic.
Enter Basic interface. See Figure 5-32.
Figure 5-113
Step 2 Set parameters.
To Next Page
Loading...
