item is for disk no space type only.
Max temperature: You can set max temperature value here. The
device can generate an alarm once the device temperature is
higher than the threshold you set. This item is for high temperature
type only.
Check the box here to enable selected function.
Please select corresponding alarm output channel when an alarm
occurs. You need to check the box to enable this function.
The alarm output can delay for the specified time after an alarm stops. The
value ranges from 0s to 300s. The default setup is 10 seconds. The o
second means there is no delaying time.
It is to set login attempt times. Once the login attempt exceeds the
threshold you set here, current account will be locked. This function is for
illegal login only.
It is to set account lock time once its login attempt has exceeded the
threshold you set. This function is for illegal login only.
System can pop up a message to alarm you in the local host screen if
you enabled this function.
System can upload the alarm signal to the center (Including alarm
center.
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Check the box here, system can record the network event alarm log.
Step 3 Click Save to complete the setup.
5.7.3.10 Alarm Output
It is to set alarm output mode.
Step 1 From main menu->Setup->Event->Alarm output.
Enter alarm output interface. See Figure 5-112.
To Next Page
Loading...
