Figure 4-169
4.14.5 People Counting (Optional)
System can calculate the entry/exit people amount in the specified zone. It can generate
an alarm when the amount has exceeded the threshold.
Step 1 From main menu->Setting->Event->People counting.
Enter people counting interface. See Figure 4-170.
Step 2 Set parameters.
Enable: Check the box to enable people counting function.
OSD overlay: Check the box here; you can view the people amount on the
surveillance video.
Rule setup: Click Set button, you can set people counting zone, name, and direction
(entry/exit).
Entry No.: It is to set people entry amount. System can generate an alarm once the
amount has exceeded the threshold.
Exit No.: It is to set people exit amount. System can generate an alarm once the
amount has exceeded the threshold.
Remaining No.: It is to set people staying amount in the zone. System can generate
an alarm once the amount has exceeded the threshold.
Refer to the chapter 4.14.3.1 motion detection to set other parameters.
To Next Page
Loading...
