bright section may over exposure .The recommended
value ranges from 40 to 60.
It is to adjust monitor window saturation. The value
ranges from 0 to 100. The default value is 50.
The larger the number, the strong the color is. This value
has no effect on the general brightness of the whole
video. The video color may become too strong if the
value is too high. For the grey part of the video, the
distortion may occur if the white balance is not accurate.
Please note the video may not be attractive if the value
is too low. The recommended value ranges from 40 to
60.
The gain adjust is to set the gain value. The default
value may vary due to different device models. The
smaller the value, the low the noise. But the brightness is
also too low in the dark environments. It can enhance
the video brightness if the value is high. But the video
noise may become too clear.
Click it to get latest setup.
Click it to restore factory default setup.
Click to cancel current setup.
Click to copy current channel setup to other channel.
4.2.6 Image
If you connected analog camera supports this function, you can set analog channel
properties.
Step 1 On the preview window, right click mouse and then select Image.
Enter image interface. See Figure 4-56.
To Next Page
Loading...
