This function allows you to view several-channel in one window. It supports
1/4/8/9-channel mode. Please go to chapter4.2.8.4(local menu) or chapter 5.7.5.2.4 (Web)
to enable zero-channel encoding function first.
5.5.2 WAN Login
In WAN mode, after you logged in, the interface is shown as below. See Figure 5-22.
Figure 5-22
Please refer to the following contents for LAN and WAN login difference.
The window display mode and the channel number are by default. For example, for
the 16-channel, the max window split mode is 16.
For multiple-channel monitor, system adopts sub stream to monitor by default.
Double click one channel, system switches to single channel and system uses main
stream to monitor. You can view there are two icons at the left top corner of the
channel number for you reference. M stands for main stream. S stands for sub stream
(extra stream).
Important
For multiple-channel monitor mode, system adopts extra stream to monitor by default.
You cannot modify manually. All channels are trying to synchronize. Please note the
synchronization effect still depends on your network environments.
For bandwidth consideration, system cannot support monitor and playback at the
same time. System auto closes monitor or playback interface when you are searching
setup in the configuration interface. It is to enhance search speed.
5.6 Search Human Face
To Next Page
Loading...
