Enter TV adjust interface. See Figure 4-60.
Figure 4-60
Step 2 Drag slide bar to adjust each item.
Step 3 Click Apply or Save to complete setup.
4.2.8.4 Zero-Channel Encoding
It is to enable and set zero-channel encoding function so that you can view several video
sources at one channel from WEB.
Step 1 From main menu->Setting->System->Display->Zero channel.
Enter zero-channel encoding interface. See Figure 4-61.
Enable: This function is disabled by default. Check the box here to enable this
function so that you can control the zero-channel encoding function at the WEB.
Compression: System default setup is H.264. You can set according to device
capability.
Resolution: The resolution value may vary due to different device capabilities. Please
select from the dropdown list.
Frame rate: PAL: 1-25f/s. NTSC: 1-30f/s. The frame rate value may vary due to
different device capabilities. Please select from the dropdown list.
Bit Rate: The default setup is 1024Kb/S. The bit rate value may vary due to different
device capabilities and frame rate setups. Please select from the dropdown list.
To Next Page
Loading...
