You can turn on or turn off the light/wiper.
Figure 5-19
5.5.1.8 Image
Here you can adjust its brightness, contrast, hue and saturation. (Current channel border
becomes green). See Figure 5-20.
Or you can click Reset button to restore system default setup.
Figure 5-20
5.5.1.9 Relay output
Here you can enable or disable the alarm signal of the corresponding port. See Figure
5-21.
Figure 5-21
5.5.1.10 Zero-channel encoding
You can click this icon to
display or hide the PTZ
control platform.
3D Intelligent Positioning
Key
To Next Page
Loading...
