Important
Shut down the device and then unplug the power cable before you open the case to
replace the HDD!
All figures listed below for reference only!
This series DVR has 1 to 8 HDDs (no limitation for capacity). Please use HDD of 7200rpm
or higher. Usually we do not recommend the HDD for the PC. You can refer to the
Appendix for recommended HDD brand.
Please follow the instructions listed below to install hard disk.
3.3.2.1 The 1U Series
The 1U series includes HCR82XXA- -S3.
This series DVR has two SATA HDDs.
① Loosen the screws of the upper
cover and side panel. Remove
the cover.
② Fix four screws in the HDD
(Turn just three rounds).
③Place the HDD in accordance
with the four holes in the bottom.
④Turn the device upside down and
then turn the screws in firmly.
⑤Connect the HDD cable and
power cable. .
⑥Put the cover in accordance
with the clip and then place the
upper cover back. Secure the
screws in the rear panel and the
side panel.
3.3.2.2 The 1.5U Series
The 1.5U series includes HCVR84XXL-S3.
This series DVR max has four SATA HDDs. Please use HDD of 7200rpm or higher.
To Next Page
Loading...
