Step 2 Set parameters.
P0: It means there is no overlay channel.
P1: There is one overlay channel.
P2: There are two overlay channels.
Note
You can set two P1 or one P2.
Step 3 Click Set button, you can use your mouse to set the overlay video to the
corresponding position. Drag the mouse to zoom in or zoom out the overlay
video.
Step 4 Click Apply to complete the setup.
Note
The PIP function is about the video collection overlay. For the video already overlaid,
it cannot be used as the main video to overlay another video. For example, once
channel 3 and channel 4 has been overlaid to channel 1, you cannot overlay other
channel to channel 3 or channel 4.
For PIP function, there is only audio output from the main video; the overlay channel
does not support audio output function.
The PIP function does not support IVS rule setup.
Figure 4-42
4.1.4.6 Storage
To Next Page
Loading...
