122
The Network interface is displayed. See Figure 4-65.
Network Figure 4-65
Select an event type. Step 2
Select the Enable check box. Step 3
Configure network abnormality parameters. See Table 4-37. Step 4
Table 4-37 Network parameter description
Parameter Description
Record
Enable this function and alarm recording will be triggered when there is an
alarm.
To view and set storage path of recorded videos, see "4.1.2.5 Configuring
Storage Path".
The following two conditions must be satisfied before alarm recording
function works:
You have enabled motion detection recording. See "4.7.1.1
Configuring Video Recording" for detailed operations.
You have enabled auto recording. See "4.7.3 Configuring Record
Control Parameters" for detailed operations.
Record Delay
Set a length of time for the Camera to delay turning off recording after an
alarm is ended.
Relay-out
You can connect this relay-out port to such alarm Cameras as light and siren.
When an alarm is triggered, those alarm Cameras will work. Select the check
box to enable this function.
Alarm Delay
Set a length of time for the Camera to delay turning off alarm after an event is
actually ended.
Click Save. Step 5
4.5.5.3 Configuring Illegal Access Parameters
If the password is continuously wrongly typed and the mistakes have reached the maximum you
have set, an alarm will be triggered and linked activities will be executed.
Select Setting > Event > Abnormality > Illegal Access. Step 1
The Illegal Access interface is displayed. See Figure 4-66.
To Next Page
Loading...
Need help?
General