5. Computer Remote Control
UniSite-xpi User Manual 5-5
CRC Default Settings
When CRC mode is entered, certain defaults are set prior to accepting any
commands. The default settings are outlined below:
If you exit remote mode using the Z, E
NTER command (or
S
HIFT +Z + ENTER), UniSite-xpi’s parameters are set to what they were
before you entered remote mode.
Description Setting
Upload/download port Remote port
Data source/destination RAM
Security fuse data (0 or 1) 0
Program security fuse No
Reject option (commercial or single) Commercial
Algorithm Source D (standard algorithms)
Logic verification option All
Number of verify passes (0, 1, or 2) 2
Fill RAM before downloading No
Illegal bit check option No
Blank check option No
Enable yield tally option No
EE bulk erase option No
Odd/even byte swap for 16 bit option No
JEDEC I/O translate DIP/LCC option Yes
Continuity check option Yes
Compare electronic signature Yes
Host command Blank
I/O address offset 0
I/O format MOS technology (format 81)
Instrument control code (0, 1, 2) 0
I/O timeout 30 seconds
Upload wait 0 seconds
Number of nulls 255
Serial set auto-increment mode No
Programming mode Single device
Total set size 1
Upload EOF delimiter flag Disabled
Download EOF delimiter flag Disabled
To Next Page
Loading...
