3. Getting Started
3-4 UniSite-xpi User Manual
Tutorials for TaskLink for Windows Mode
Sessions 1-5 take you through the basic process of programming a device
using TaskLink for Windows as your user interface.
Before you go any further in this chapter, make sure you have read and
completed the instructions in Chapter 2, “Setup and Installation.” You
should also have read Chapter 1, “Introduction.”
For these Sessions, you will use TaskLink for Windows in simulation
mode, and you do not need to have your programmer connected.
Session 1: Selecting a Device
On the TaskLink main screen, under the System menu select Select
Programming System.
From the Programmer Type list, highlight UniSite-xpi and click OK.
Figure 3-2
System Menu: Select Programming
System
Figure 3-3
Programmer Type
To Next Page
Loading...
