1. Introduction
UniSite-xpi User Manual 1-7
Safety The UniSite-xpi and all legacy programmers are certified by UL to comply
with the following safety standards:
Electrostatic
Discharge (ESD)
IEC 801-2 (± 8kV)
Electromagnetic
Emissions
UniSite-xpi (part number 991-0014-058 and earlier versions) is certified to
meet VDE 0871 Limit B.
Certificate of
RFI/EMI Compliance
Data I/O certifies that the UniSite-xpi and all legacy programmers
comply with the Radio Frequency Interference (RFI) and Electromagnetic
Interference (EMI) requirements of EN55022 Class A and EN50082-1 as
called out in 89/336/EEC, the EMC Directive for the European
Community.
WARNING: This equipment is a class A product. In a domestic
environment this product may cause radio interference, in which case
the user may be required to take adequate measures.
Performance
Verification
UniSite-xpi verifies internal voltages every time it is powered up and
every time a complete self-test is run. The voltage verification is
performed by software and is compared to a laser-trimmed voltage
reference.
Data I/O recommends that you cycle power AND run a complete self-
test cycle at least every three months.
To ensure that your UniSite-xpi continues to meet product performance
specifications, Data I/O recommends that your programmer be returned
to an authorized Data I/O Service Center every twelve months for a
complete performance evaluation.
Figure 1-4
UL Symbol Underwriters Laboratories —
UL 60950 Third Edition and/or
EN 60950 Third Edition
Figure 1-5
CE Symbol EC Conformity Mark
LISTED
3T26 I.T.E.
To Next Page
