3. Getting Started
3-20 UniSite-xpi User Manual
From the Program menu, select Select Process. An X in the selection box
indicates that process will be performed. When the appropriate processes
are selected, click OK.
Session 10: Programming a Device
From the Program menu, select Process Devices. In the Pass Limit field,
enter the number of devices you want to program. To program an
unlimited number of devices, set the value at “0.”
You may also enter a Session ID name or number. A Session ID is
optional and helps when tracking statistics.
When actually programming a device, you will be prompted to insert the
device to be programmed. For information about inserting devices, see
“Install Devices” on page 2-30.
Figure 3-33
Selecting Processes
Figure 3-34
Process Devices
To Next Page
Loading...
