Data I/O UniSite-xpi - Page 240

6. Translation Formats
6-2 UniSite-xpi User Manual
Below you will find a list, in ascending numerical order, of all the
translation formats supported by the programmer. Following the list is a
description and, in most cases, an example of each translation format,
presented in order by format number.
* This alternate code is used to transfer data without the STX start code and the ETX end
code.
** This alternate code is used to transfer data using the SOH start code instead of the
usual STX.
Format Code Format Code
ASCII-BNPF 01 (05*) RCA Cosmac 70
ASCII-BHLF 02 (06*) Fairchild Fairbug 80
ASCII-B10F 03 (07*) MOS Technology 81
Texas Instruments
SDSMAC (320) 04
Motorola EXORcisor
Intel Intellec 8/MDS
82
83
5-level BNPF 08 (09*) Signetic Absolute Object 85
Formatted Binary 10 Tektronix Hexadecimal 86
DEC Binary 11 Motorola EXORmacs 87
Spectrum 12 (13*) Intel MCS-86 Hex Object 88
POF
Absolute Binary
14
16
Hewlett-Packard 64000
Absolute 89
LOF
ASCII-Octal Space
17
30 (35**)
Texas Instruments
SDSMAC 90
ASCII-Octal Percent 31 (36**) JEDEC format (full) 91
ASCII-Octal
Apostrophe
ASCII-Octal SMS
32
37
JEDEC format (Kernal
Tektronix Hexadecimal
Extended)
92
94
ASCII-Hex Space 50 (55**) Motorola 32 bit (S3 record) 95
ASCII-Hex Percent
ASCII-Hex Apostrophe
51 (56**)
52
Hewlett-Packard UNIX
Format 96
ASCII-Hex SMS 57 Intel OMF 386 97
ASCII-Hex Comma 53 (58**) Intel OMF 286 98
Intel Hex-32 99