DIMENSIONING SETUP AND CALIBRATION
5 DIMENSIONING SETUP AND CALIBRATION
This chapter provides details on how to set up and calibrate the Two-Head Dimensioning
System for normal operation and references several sections in this manual. For a step-by-
step procedure for installing and calibrating this system, see the Two-Head Dimensioning
System Installation Guide.
IMPORTANT: The procedures outlined in this chapter should only be
performed by a Datalogic trained technician.
Training is available through specific Service Programs and Maintenance
Agreements. See our website at www.datalogic.com.
5.1 SYSTEM SETUP
Install the structure, Universal Mounting Brackets (UMBs), DM3610 dimensioners, DC3000
Dimensioning Controller and other equipment as indicated in chapter 2, Mechanical
Installation.
Install the system cabling as described in chapter 3, Electrical Installation.
IMPORTANT: The DM3610 Dimensioners must be pre-configured
before they are mounted to their UMBs as shown in section 2.4.12
of this manual.
To Next Page
Loading...